Italiano

HSW accessories

Hooks, pegs, tool racks and bins that clip into honeycomb panel cells. HSW-compatible.

What is HSW

Honeycomb Storage Wall is an open standard for honeycomb pegboards: panels with 20 mm hexagonal cells where hooks, pegs and bins snap in, no screws. The accessories on this page fit any HSW panel.

No panel yet? Generate one here →

Configure the part

Accessory

90° = vertical tip. Below 90° the tip leans toward the wall and holds better.

Your panel: Standard HSW (20 mm) Edit

Our current Hex panel is standard HSW. If you changed its dimensions, enter the same values here.

Too tight? Increase by 0.05. Wobbly? Decrease.

The preview shows it as mounted; the file is already turned for printing: it prints on its side, support-free, with layers along the arm so it won't snap at the root under load.

HSW-compatible (RostaP's Honeycomb Storage Wall), so it fits our Hex panel too. The snap tabs click into the step at the back of the cell. Print a test hook first to dial in the clearance.

3D preview

The right filament for this project

PETG is ideal for load-bearing accessories: tough, and the snap tabs flex without breaking. PLA+ works too.

Compare deals: PETG →